22 23
INITIAL SET UP INITIAL SET UP
CONNECT LOW PRESSURE (LP) HOSE TO REGULATOR
Connect the low pressure (LP) Hose of the Power Inflation Valve or A.I.R. 2 to an unused LP
Port of the first stage. Ensure that the thread of the hose matches the thread of the LP port.
WARNING
Do not attach a L.P. hose to a SCUBA regulator high pressure (HP) port or to an
air supply with pressure in excess of 200 psi (13.8 bar). This may result in dam-
age or explosive failure of the Inflation Valve or Low pressure Hose, which could
result in injury or death.
To Next Page
