Need help?Do you have a question about the Uwatec SMART TEC and is the answer not in the manual?
General| Display Type | LCD |
|---|---|
| Water Resistance | 100 meters |
| Nitrox Capability | Yes |
| Maximum Operating Depth | 100 meters |
| Operating Modes | Air, Nitrox, Gauge |
| Battery Type | CR2450 |
| Nitrox Compatibility | 21-50% O2 |
| Battery Life | 2 to 3 years (approximately 300 dives) |
Safety guidelines for using the Smart TEC, covering Nitrox, gas mixtures, and operational procedures.
Explanation of warning symbols and icons used in the manual for safe operation.
Overview of display elements, button operations, and contact functions for the dive computer.
Overview of the Smart TEC dive computer, its components, and data transmission capabilities.
Details the physical contacts and their functions for manual operation.
Describes the SmartTRAK software for data transfer and computer settings customization.
Explains the automatic activation of SOS mode and its implications.
Step-by-step guide for mounting the transmitter and pairing it with the dive computer.
Explains dive terms, Nitrox settings, ppO2, MOD, oxygen toxicity, and attention messages.
Guide to setting gas mixtures, MOD, and microbubble levels before a dive.
Covers immersion, depth measurement, maximum depth, and ascent rate monitoring.
Details oxygen toxicity, tank pressure, warnings, and Remaining Bottom Time (RBT).
Covers decompression information, no-stop time, decompression values, and safety stops.
Displays desaturation time, no-fly time, and explanations of microbubble warnings.
How the computer adapts to altitude, restrictions, and decompression at height.
Steps to activate gauge mode, its functions, and changing gas mixtures.
How to use the built-in stopwatch for timing dives and split times.
Compares dive profiles and requirements between MB levels, and explains terminology.
Instructions on how to select and set the desired microbubble level.
Displays and warnings related to level stops required by MB levels.
Warnings for ignored or reduced level stops and ascent guidance.
Calculation and display of total ascent time including level stops.
Overview of using multiple gas mixtures, preparation, and switching off unused mixtures.
Procedures and warnings for changing gas mixtures during a dive.
Steps to plan no-stop and decompression dives using the dive planner.
Overview of dive data recorded in the logbook and how to access it.
Specifications, care, and detailed steps for replacing the transmitter battery.
Chart for pressure conversion and information regarding product warranty.
List of warranty exclusions and FCC compliance statement.
To Next Page