Uwatec SMART TEC User Manual

Stopwatch
In gauge mode, after immersion, TEC will automatically monitor the dive time
and at the same time activate the stopwatch. If the gauge symbol and "on"
are displayed (-> 26, point 1) the stopwatch can also be activated at the surfa-
ce by pressing . The stopwatch will run for a maximum of 1 hour at the
surface and no longer than 24 hours underwater.
By pressing you can start, stop and restart the stopwatch.
Once the stopwatch has been stopped, you can reset the timer to zero with
.
While the stopwatch is running you can measure split times and return to the
timer display by pressing . The timekeeping is not interrupted in the
meantime.
• By pressing you can select a different pressure tank even while the
stopwatch is running or the split time is being displayed.
• At a diving depth of less than 0.8m (3 ft) the stop watch will automatically
measure and display the split time. If the diver descends again the stopwatch
timer will be displayed again.
After diving in gauge mode
TEC shows the remaining time span during which it cannot be used in compu-
ter mode. Once the waiting period is over, the gauge mode can be switched
off manually. ->26
The no-fly time after diving in gauge mode is 48 hours.
Desaturation time will not be displayed.
English
27
IV Gauge mode
IV UWATEC
®
Smart dive computers
III
Hours
Minutes
Seconds
Stopwatch icon
Timing
NO
Stopwatch activated
00h00 00
Example
Time reset00h00 00
Stopwatch is running
Split time
(stopwatch continues to
run in the background)
00h00 15
Stopwatch halted00h02 35
Stopwatch
will start
automatically
after
immersion
Automatically
at the end of
dive
Exit stopwatch
Icon for split time
When split time is
taken, the temperature is
displayed for 5 seconds.

Uwatec SMART TEC Specifications

General

Brand	Uwatec
Model	SMART TEC
Category	Diving Instrument
Language	English