34 35
SINGLE CYLINDER ATTACHMENT
The SCUBAPRO Super Cinch Quick Adjust cylinder strap allows you to easily fasten your BC
to any single SCUBA cylinder by following these steps:
a. Wet the webbing of the Super Cinch Q.A. cylinder strap.
b. Hook the Tank Locator Strap over the cylinder valve, position the BC so that the cylinder
rests against the Tank Grips and then adjust the Tank Locator Strap to provide the
desired cylinder height relative to the BC.
c. Open the stainless steel buckle then wrap the strap around the cylinder and hook the
stainless steel D-ring onto the stainless steel buckle.
d. Lever the buckle closed, tightening the strap in the process.
e. If the strap is too tight to close or too loose, open the buckle and adjust the strap length
by releasing the Velcro and repositioning the D-ring. Re-fasten the loose end of the strap
using the Velcro sections and for extra safety, slide the plastic loop over the webbing end.
f. To test the security of the cylinder, lift the assembly by the BC back pack handle and shake
firmly. If there is movement between the BC and the cylinder, the strap is not tight enough.
SINGLE CYLINDER ATTACHMENT
WARNING
To prevent accidental loss of the cylinder, ensure the strap is done up tightly
enough so that the cylinder cannot move or slide on the BC. Failure to do so could
result in injury or death.
WARNING
Soak the webbing of the SCUBA air cylinder strap and then tighten prior to each
use of the BC. Webbing may stretch when initially exposed to water. Failure to
soak the webbing may allow the cylinder strap to loosen around the SCUBA air
cylinder.
WARNING
Check the correct positioning and the correct tightening of the tank straps before
starting to dive.
To Next Page
Loading...
