38 39
VALVE SYSTEM
VALVE SYSTEM SET UP
TO ATTACH THE QUICK DISCONNECT COUPLING:
a. Ensure the air supply is turned o at the cylinder valve and that the air pressure is purged
from the regulator system.
b. Make sure that both fittings are free of contamination prior to mating them together.
c. Pull back the collar of the Quick Disconnect Coupling, while pushing the hose firmly onto
the Inlet found on the Power Inflation Valve.
d. Release the collar when the Coupling is fully seated on the Inlet. Pull gently but firmly on
the hose to check for a secure connection.
TO DISCONNECT THE QUICK DISCONNECT COUPLING:
a. Ensure the air supply is turned o at the cylinder valve and that the air pressure is purged
from the regulator system.
b. Pull the Quick Disconnect Coupling Collar back and disengage the LP Hose and Coupling
from the plug.
VALVE SYSTEM
WARNING
AIR2 uses a dedicated quick disconnect coupling. When using AIR2 be sure to
use only the SCUBAPRO dedicated hose supplied with the specific quick
disconnect coupling.
WARNING
KEEP WATER OUT OF THE INFLATABLE AIRCELL OF THE BC. Repeated use of the
oral valve or the Overpressure Valve may allow water inside the BC, reducing the
amount of buoyancy provided by the BC. This could result in injury or death. Drain
all water out of the BC prior to every use.
WARNING
KEEP SAND AND OTHER CONTAMINATION OUT OF THE ORAL VALVE MOUTHPIECE
AND VALVE BUTTON. Under certain conditions, contamination can cause the valve
to not close completely. If this occurs while diving, shake the valve while depress-
ing it several times. If the valve leaks or remains inoperable, terminate the dive.
Diving with a leaking Buoyancy Compensator or with valves that do not operate
properly may result in a loss of buoyancy control that could result in injury or
death.
To Next Page
Loading...
