SCUBAPRO S600-S550 SECOND STAGES
2003 SCUBAPRO
Important note
: The following information is not designed to be a complete training guide for servicing the listed SCUBAPRO regulators. All SCUBAPRO
technicians are required to attend an annual service training program to insure safe handling and servicing of SCUBAPRO products. All SCUBAPRO technicians
must be employed by an authorized SCUBAPRO facility.
13
Monoject
Lubricate all dynamic o’rings properly and
replace. Carefully inspect and lubricate all
static o’rings and replace where needed.
P
/
N
4
3
0
4
0
0
0
0
TOOLS
NEEDED
No tools needed
this step
Assemble the two-piece balance chamber
as shown and insert it into the cracking
effort adjustment knob.
Do not install the “anti-set chamber” into
the end of the assembly at this time. The
balance chamber adjustment tool should
be installed in preparation for final
adjustments.
NOTE: The spring pad can be installed on
the poppet or the balance chamber.
P
/
N
4
3
0
4
0
0
0
0
TOOLS
NEEDED
No tools needed
this step
Insert the air barrel and breathing
adjustment assembly (without the
external knob) into the regulator body.
If necessary, use the universal tool and
jam nut to assist in pulling the air barrel
all the way through the regulator case.
To Next Page
Loading...
Need help?
General
