UWE ADW-E Series - Data Transmission Mode

d. Press TARE four times
e. Scale displays F.5
f. Press MODE to select baud rate of 4800, 9600, 19200,
38400
g. Press and hold MODE for 2 seconds to enter
transmission protocol setup
h. Press MODE to select protocol of N81 or E71
i. When the preferred transmission protocol shows on
display, press ON/ZERO to confirm and restart the
scale or TARE for next function setup
NOTE:
The default data output format of the scale is
Baud Rate = 9600
Data Bit = 8
Stop Bit = 1
Parity = None
4.2.4 Select Data Transmission Mode
This scale provides 2 types of transmission mode
depending on the requirement and environment.
a. Scale is off
b. Press and hold TARE, then press ON/ZERO
c. Scale displays F.1