NOTE:
Weight Check Function will not valid when the weight
unit engaged (e.g. lb) is different from the original
weight unit programmed under (e.g. gram).
Weight Check Function will not valid when the weight
is less than minimum load. Please refer to SPECIFICATION
for minimum load of each capacity.
Weight Check Function will not valid when high and low
weight limits are not logical (e.g. value of high weight
limit is less than the value of the weight limit set).
To disable Weight Check Function, simply set the high
weight limit to zero or set the buzzer warning to bb_no.
to turn off the warning.
5.8.2 Weight Check Transaction
Place a subject matter onto the platter. The Weight Check
result is displayed on the display.
a. The HI INDICATOR will appear when weight detected
over the high weight limit preset.
b. The OK INDICATOR will appear when weight detected
within the high upper and low weight limit.
c. The LO INDICATOR will appear when weight detected
under the low weight limit preset.
To Next Page
Loading...