Illustration
Quick Guide
1. Take the pod off the device and remove the insulating
film from the bottom of the pod.
2. Open the filler plug and fill it with e-liquid, and then put
the filler plug back. Let the pod sit for 10 minutes.
3. Install the pod into the device and make sure it is
properly installed.
4. Press the fire button 5 times in 2 seconds to turn on the
device for vaping.
Filler plug
E-liquid
container
Device
Drip tip
Air
adjustment
valve
Fire button
Adjustment
knob
Type-C port
- 1 -
To Next Page
Loading...
