To Next PageTo Next Page
Need help?Do you have a question about the V2 TORQ Series and is the answer not in the manual?
General| Brand | V2 |
|---|---|
| Model | TORQ Series |
| Category | Gate Opener |
| Language | English |
Instructions for correctly positioning the motor unit on the anchoring plate.
How to adjust motor power, obstacle sensitivity, and pause time using trimmers.
Configuring control unit functions using DIP switches for various modes.
Connecting the main 230Vac 50Hz power supply to the unit.
Wiring instructions for the 230V flashing light indicator.
Connecting auxiliary devices like electric locks or courtesy lights.
Connecting photocells, safety edges, and other safety devices.
Connecting a pilot light to the GSI input for gate status indication.
Wiring inputs for start, stop, and pedestrian commands.
Connecting an external antenna to improve radio reception range.
Programming a transmitter button for the basic start function.
Programming a transmitter button for partial pedestrian opening.
Erasing all programmed transmitters from the control unit's memory.
Removing a specific transmitter from the control unit's memory.
Programming remote transmitters for advanced functions.
Basic self-learning for manoeuvre times and slowdown start points.
Adjusting the partial opening width for pedestrian access.
Advanced self-learning and manual setting of manoeuvre times.
Explanation of LEDs indicating the status of control unit inputs.
Interpretation of error codes indicated by the red 'ERROR' LED.
Assigning a transmitter button to control the AUX output.
Choosing the function for the AUX output (electric lock, courtesy light).
Enabling or disabling the photocell safety test.
Choosing operating modes for wired start and pedestrian contacts.
Locking or unlocking programming sequences and settings.
Restoring the control unit to its factory default settings.
