Need help?Do you have a question about the VAC V200P and is the answer not in the manual?
General| Category | Controller |
|---|---|
| Output Voltage | 24 VDC |
| Output Current | 8.5 A |
| Power | 200 W |
| Efficiency | >90% |
| Protection | Overload, Overvoltage, Short Circuit |
| Operating Temperature | -20°C to +60°C |
| Storage Temperature | -40°C to +85°C |
Provides critical safety warnings regarding moving parts, voltage, pressure, and operational limits.
Details the V200's standard C1-cam, its settings, and adjustment procedures.
Describes the process of installing the internal IP converter into the positioner housing.
Details how to connect, check the control signal, bench test, and test the IP internal circuit.
Explains the factory calibration and the procedure for setting zero and span.
Steps for pilot valve removal, cleaning, and reinstallation, including spool alignment.
To Next Page
