Vacmaster UC0101 - Cleaning the Primary Filter

-20-
4. If necessary, rinse the pre-lter with cold water only. Do not use detergent or
soap. Set the pre-lter aside and allow to air dry for 24 hours.
Do not wash in the dishwasher. Do not install damp.
IMPORTANT:
The lters must dry completely before reuse.
5. Reinstall the lower portion of the dust cup by aligning marks to the locked position
as shown below.
6. Rotate the dust cup lid assembly clockwise until marks align as shown above
in
LOCKED
.
7. Reinstall the dust cup into the main body. See installation instructions in the
Emptying the Dust Cup.
Cleaning the Primary Filter
The primary lter is located inside the dust cup lid.
It is recommended to clean the primary lter with cold water at least once a
month. Check the primary lter frequently and clean when dirty.