Vacmaster VK1323PFR - Troubleshooting

17
GB
WARNING!
TO REDUCE THE RISK OF ELECTRIC SHOCK, UNPLUG BEFORE
TROUBLESHOOTING.
Cleaning Performance
Vacmaster vacuum cleaners are tested for endurance. If your motor is operating, then the most
likely cause for a loss in suction is a blockage or an opening in the vacuum.
To maintain a high cleaning performance from your machine, it is important to replace or clean
cartridge lters as necessary. A performance drop with clean lters can only be caused by a
blockage in the tools or the hose.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
The appliance
does not work.
No power. Check the power supply and fuse.
Functional fault in the power cord,
switch, or motor.
Have the damaged part checked by
qualied personnel or contact the after
sales helpline.
Dust is escaping
from the motor
cover.
The cartridge lter is missing or
damaged.
Put in a cartridge lter or replace it.
Misuse the cartridge lter when
wet vacuuming, causing the
damage of cartridge lter.
Replace the damaged cartridge lter
with a new one when dry vacuuming.
Misuse the foam lter when dry
vacuuming.
Replace the foam lter with the cartridge
lter.
Low suction power
and high operating
noise / vibrations.
Suction nozzle, hose, or tank inlet
is blocked.
Check the suction nozzle, hose, and
tank inlet for obstructions.
Cartridge lter is blocked.
Remove the cartridge lter and clean.
Float valve has closed.
Empty the container of any liquid waste
and ensure the oat valve located
underneath the lter is able to move freely.
No solution
spraying out.
Detergent mode is not selected. Press the detergent mode button.
Detergent tank is empty. Add more detergent.
Incorrectly tted pipes.
Check ttings and connections. Ensure
there are no kinks in tubes.
The water pump inside the power
head overheats.
Let the vacuum cool down to reach a
normal temperature, then re-start the
vacuum.
Foam is escaping
from the air outlet
on motor cover.
Misuse the high foaming shampoo
detergent.
Replace with low foaming shampoo
detergent.
The remote control
does not work.
The battery is depleted.
Replace the old battery with a new one.
The remote control is not paired
correctly.
Reset the remote control follow the
instructions on page 12.