Vacon NXL series - Keypad Buttons and Descriptions

Control keypad vacon • 51
24-hour support: +358-40-8371 150 • Email: vacon@vacon.com
7
7.2 Keypad push-buttons
The Vacon seven-segment control keypad features 7 push-buttons that are used for the control of
the frequency converter (and motor) and parameter setting.
Figure 7-2. Keypad push-buttons
7.2.1 Button descriptions
ENTER
reset = There are two operations integrated in this button. The button operates
mainly as reset button except in the parameter edit mode. The button
operation is shortly described below.
ENTER = The Enter button serves for:
1) confirmation of selections
2) fault history reset (2…3 seconds)
reset = This button is used to reset active faults.
Note! The motor may start immediately after resetting the faults.
= Browser button up
Browse the main menu and the pages of different submenus.
Edit values.
= Browser button down
Browse the main menu and the pages of different submenus.
Edit values.
= Menu button left
Move backward in menu.
Move cursor left (in parameter edit mode).
Exit edit mode.
Hold down for 2…3 seconds to return to main menu.
= Menu button right
Move forward in menu.
Move cursor right (in parameter edit mode).
Enter edit mode.
–
3
4
+