Vacon NXL series - Page 67

Control keypad vacon • 67
24-hour support: +358-40-8371 150 • Email: vacon@vacon.com
7
T6.8.2.4
Operating hours trip
counter
hh:mm: ss
P6.8.2.5
Clear operating time
counter
0 = No action
1 = Clear
T6.8.2.3, T6.8.2.4
S6.8.3 Software info
I6.8.3.1 Software package
Scroll information with menu
button right
I6.8.3.2 System SW version
I6.8.3.3 Firmware interface
I6.8.3.4 System load %
S6.8.4 Application info
S6.8.4.1 Application
A6.8.4.1.1 Application id
A6.8.4.1.2 Application version
A6.8.4.1.3 Firmware interface
S6.8.5 Hardware info
I6.8.5.2 Unit voltage V
I6.8.5.3 Brake chopper
0=Not present, 1=Present
S6.8.6 Options
S6.8.6.1 Slot E OPT-
Note! the submenus are not
showing if no option board is
installed
I6.8.6.1.1 Slot E Status 1 5
1=Connection lost
2=Initializing
3=Run
5=Fault
I6.8.6.1.2 Slot E Program version
S6.8.6.2 Slot D OPT-
Note! the submenus are not
showing if no option board is
installed
I6.8.6.2.1 Slot D Status 1 5
1=Connection lost
2=Initializing
3=Run
5=Fault
I6.8.6.2.2
Slot D Program
version
S6.9 AI mode
P6.9.1 AIA1 mode 0 1 0
0=Voltage input
1=Current input
(Types MF4 – MF6)
P6.9.2 AIA2 mode 0 1 1
0=Voltage input
1=Current input
S6.10 Fieldbus parameters
I6.10.1 Communication status
P6.10.2 Fieldbus protocol 1 1 1
0=Not used
1=Modbus protocol
P6.10.3 Slave address 1 255 1 Addresses 1 – 255
P6.10.4 Baud rate 0 8 5
0=300 baud
1=600 baud
2=1200 baud
3=2400 baud
4=4800 baud
5=9600 baud
6=19200 baud
7=38400 baud
8=57600 baud
P6.10.5 Stop bits 0 1 0
0=1 1=2
P6.10.6 Parity type 0 2 0
0=None 1=Odd 2=Even
P6.10.7
Communication
timeout
0 300 s 0
0=Not used1=1 second
2=2 seconds, etc
Table 7-5. System menu functions