22
5. Make sure that all connectors are properly seated before closing the cover again.
在关闭界面盒之前，请再次确认所有的连接均被正确就位。
6. Close the cover of the interface box. 关上界面盒。
6.6 CONNECTION OF SENSOR TO INTERFACE BOX 将探头与界面盒连接
Figure 10
Tighten the cable gland with a spanner.
图
10 使用螺丝钳紧固缆线封压盖
Figure 11
Install the numbered wires in the appropriate
terminals of Terminal J6, see figure 12
图
11 将已编号的缆线连接在终端J6的适当位置
上，见图12
To Next Page
Loading...
