29
VRC 700 Commissioning / Configuration
When the VRC 700 is powered up for the first time, the start up assistance will guide
you through several basic settings.
VRC 700/5 & VRC 700f
1
Use the rotary knob to scroll through the
different language options and then press
‘OK’ (the selection button below the
display, on the right) to select your
language of choice.
2
Use the rotary knob to scroll through the
selection. Press ‘OK’ (the selection button
below the display, on the right) to move to
the month selection, then again to the
year, and once more to move to the next
screen.
3
In the same manner as previous, select the
time.
4
Ensure that all other equipment in the
system connected via eBUS is set up
appropriately and ready before moving on.
5
Scroll through and confirm that all other
equipment in the system connected via
eBUS is displayed on this screen. If there
are any missing components it is
recommended to switch off all power and
check eBUS polarities where the terminal
shows ‘+’ & ‘-‘.
To Next Page
Loading...
Need help?
General
