Need help?Do you have a question about the Vaillant ecoTEC plus 620 and is the answer not in the manual?
General| Boiler Type | Combi |
|---|---|
| Mounting | Wall-mounted |
| Output Power | 20 kW |
| Efficiency (%) | 94 |
| ErP Rating | A |
| Dimensions (H x W x D) | 720x440x338 mm |
| Heating Circuit | Yes |
| Modulation | 1:4 |
| Warranty | 5 years |
| Fuel Type | Natural gas |
Conveys critical safety information to prevent hazards.
Outlines the product's built-in safety mechanisms.
Details requirements for the gas supply and meter.
Emphasizes using the specified gas type to avoid faults.
Explains how to ensure correct system pressure using an expansion vessel.
Guides the installation of the air and flue system components.
Provides instructions for installing and connecting the air/flue pipe.
Guides the safe and correct installation of the gas pipe.
Explains how to connect the water supply lines.
Guides the connection of the heating flow and return pipes.
Details the installation of the condensate discharge system.
Provides comprehensive instructions for electrical connections.
Describes how to access the installer settings menu.
Details how to view and adjust diagnostic codes.
Explains how to initiate and run system check programmes.
Guides on testing individual system components (actuators).
Details the procedure for combustion analysis.
Lists essential checks before initial power-on and commissioning.
Guides the procedure for the initial product start-up.
Covers water quality checks and treatment for the heating system.
Details the automated setup process for new installations.
Step in the installation assistant for filling the heating system.
Step in the installation assistant to select the correct gas type.
Details how to ensure correct system pressure during filling.
Guides the initial cold flush of the heating system.
Provides detailed steps for filling the heating system with water.
Guides on removing air from the heating installation.
Explains how to fill and purge the domestic hot water system.
Details the procedure for filling the condensate siphon with water.
Outlines essential checks for gas settings and compatibility.
Verifies the factory gas setting against the site conditions.
Details checks for air/flue system integrity and recirculation.
Guides on measuring gas pressures at the inlet.
Describes how to measure and interpret oxygen content for combustion analysis.
Guides on measuring and verifying the gas flow rate.
Details the hot flush procedure for the heating system.
Instructs on checking for leaks in various circuits.
Guides on setting essential system parameters.
Covers adjustments for heating mode operation.
Covers settings related to the water flow temperature.
Explains selection of hydraulic operating modes.
Details how to set the heating system's pressure level.
Covers adjustments for domestic hot water settings.
Explains setting the DHW temperature and legionella prevention.
Provides a general overview of annual inspection and maintenance requirements.
Describes how fault messages are displayed and handled.
Steps to resolve detected faults.
Explains reversible and irreversible limp home mode messages.
General procedures for fault elimination.
Detailed instructions for replacing parts.
Procedures for clearing condensate blockages.
Detailed steps for replacing the gas valve assembly.
Instructions for removing and replacing the heat exchanger.
Details on replacing the ignition electrode.
Guides on replacing the control electrode.
Guides the initial setup and configuration process.
Configuring the system's hydraulic operating mode.
Selecting the correct gas type for the installation.
Accessing and managing diagnostic codes.
To Next Page
