8 Operating instructions 0020308119_02
3.5 UKCA mark
The UKCA marking shows that the
products comply with the basic require-
ments of the applicable directives as
stated on the declaration of conformity.
The declaration of conformity can be
viewed at the manufacturer's site.
3.6 Hot Water Association
Vaillant is a full member of the Hot Water
Association and promotes the scheme
in association with its cylinder range.
Details are available on the web site
www.vaillant.co.uk
3.7 Benchmark
Vaillant is a licensed member of the
Benchmark Scheme which aims to im-
prove the standards of installation and
commissioning of domestic heating and
hot water systems in the UK and to en-
courage regular servicing to optimise
safety, efficiency and performance.
Benchmark is managed and promoted
by the Heating and Hotwater Industry
Council. For more information visit
www.benchmark.org.uk.
▶ Please ensure that the installer has fully
completed the Benchmark Checklist on
the inside back pages of the installation
instructions supplied with the product
and that you have signed it to say that
you have received a full and clear ex-
planation of its operation. The installer
is legally required to complete a com-
missioning checklist as a means of
complying with the appropriate Build-
ing Regulations (England and Wales).
All installations must be notified to Local
Area Building Control either directly or
through a Competent Persons Scheme.
A Building Regulations Compliance Certi-
ficate will then be issued to the customer
who should, on receipt, write the Notifica-
tion Number on the Benchmark Checklist.
This product should be serviced regularly
to optimise its safety, efficiency and per-
formance. The service engineer should
complete the relevant Service Record on
the Benchmark Checklist after each ser-
vice.
The Benchmark Checklist will be required
in the event of any warranty.
4 Operation
4.1 Operating concept
Control elements that are lit up in colour
can be selected.
Adjustable values and list entries can be
changed using the scrollbar. Briefly tap on
the top and bottom end of the scrollbar in
order to implement changes.
You must confirm a change to a value.
Only then is the new setting saved. You
have to press flashing control elements
again to confirm.
Control elements that are lit up in white are
active.
The menu and the control elements are
dimmed after 60 seconds in order to save
energy. The status display is shown after
another 60 seconds.
You can find additional assistance for the
control elements under MAIN MENU →
INFORMATION → Control elements.
To Next Page
Loading...
Need help?
General
