What to do if Vaillant ecoTEC plus temperature rises too quickly?
If your Vaillant Boiler experiences a rapid temperature increase due to water shortage, the pump may be blocked, have insufficient output, or there might be air in the system, or the water pressure might be too low. Check the pump for blockages and make sure the water pressure is adequate.
What to do if my Vaillant Boiler flame goes off during operation?
If the flame goes off during operation and subsequent ignition attempts fail, it could be due to a temporarily stopped gas supply or faulty earthing of the appliance. Check the gas supply and earth connection.
What to do if my Vaillant Boiler is overheating?
If the overheating protection on the primary heat exchanger is triggered, it could be due to a defective cable or cable connection of the fuse in the primary heat exchanger, or the primary heat exchanger itself being defective. Inspect primary heat exchanger connections.
What to do if my Vaillant Boiler shows water shortage and large temperature difference?
A water shortage with a large temperature difference between the flow and return NTC in your Vaillant Boiler could be caused by a blocked or defective pump, the pump output being too low, or the flow and return NTCs being interchanged. Check pump and NTC placements.
Why is there a large temperature difference in my Vaillant Boiler?
If there's a significant temperature difference between the flow and return NTC in your Vaillant Boiler due to a water shortage, the pump might be blocked or defective, have insufficient output, or the flow and return NTCs may be interchanged. Check the pump for any blockages or defects.
What to do if the central heating thermostat knob is turned off or there is no heat demand by the eBUS control unit in my Vaillant ecoTEC plus?
If the central heating thermostat knob is turned off or there is no heat demand by the eBUS control unit in your Vaillant Boiler, turn the central heating thermostat knob to the desired setting.
What to do if Safety temperature limiter by NTC is activated on my Vaillant Boiler?
If the safety temperature limiter by NTC is activated on your Vaillant Boiler, it's because the Flow-NTC is not correctly thermal-connected or defective, and the appliance does not shut down. Check and correct thermal connection of Flow-NTC.
What to do if my Vaillant ecoTEC plus Boiler has no heat demand?
To resolve the issue of no heat demand in your Vaillant Boiler, check that all external controls are on and calling for heat. If no external controls are fitted, boiler terminals 3 and 4 must be linked.
What does it mean if my Vaillant Boiler reports Flow and/or return NTC fault?
If your Vaillant Boiler reports a Flow and/or return NTC fault, it means the Flow and/or return NTC is defective (tolerances too big). Replace the Flow and/or Return NTC.
What to do if my Vaillant ecoTEC plus Boiler electronics temperature is too high?
If the electronics temperature is too high in your Vaillant Boiler, it could be due to the electronics being too hot from an external effect, or the electronics being defective. Ensure proper ventilation for electronics.
General| Model | ecoTEC plus |
|---|---|
| Category | Boiler |
| Type | Condensing |
| Dimensions (H x W x D) | 720mm x 440mm x 338mm |
| ErP Rating | A |
| Mounting | Wall-mounted |
| Output Range | 12kW to 38kW |
| Fuel Type | Natural Gas |
| Domestic Hot Water Output | 38kW |
| Flow Rate | 15.9 l/min |
| NOx Emissions | Class 5 |
| Efficiency | 94% (SAP 2009) |
To Next Page