Appendix B ____________________________________ PWC22/52 Connectors and Jumper Settings
VAISALA ______________________________________________________________________ 107
APPENDIX B
PWC22/52 CONNECTORS AND
JUMPER SETTINGS
X1-1 Chassis (GND)
X1-2 RS-485 (B) (WHT)
X1-3 RS-485 (A) (BRN)
X1-4
1) DC power for measurement electronics (+, RED)
X1-5
1) DC power for measurement electronics (-, BLK)
X2-1 RS-232 (GND, GRY)
X2-2 RS-232 (TxD, GRN)
X2-3 RS-232 (RxD, YEL)
X2-4 Module 5
X2-5 Module 4
X2-6 Module 3
X2-7 Module 2
X2-8 Module 1
X3-1 Background Luminance Sensor PWL111 (Range, YEL)
X3-2 Background Luminance Sensor PWL111 (Level, GRN)
X3-3 Background Luminance Sensor PWL111 (+5 VA, RED)
X3-4 Background Luminance Sensor PWL111 (AGND, BLK)
X3-5
1) Separate heating power input for PWH111hood heaters
(+, BRN/GRN and WHT/GRN)
X3-6
1) Separate heating power input for PWH111hood heaters
(-, WHT/YEL and YEL/BRN)
X3-7
1) PWH111hood heater foil (+)
X3-8
1) PWH111hood heater foil (-)
X3-9 Ext Voltage +12 V (analog output current source (PNK)
X3-10 Ext (modem) control 1
X3-11 Ext (modem) control 2
X3-12 Analog output current sink (range is chosen by jumper X13
located under the PWC15PB), (BLU)
X4-1 Temperature sensor PT100 (+, BLU)
X4-2 Temperature sensor PT100 (+, YEL)
X4-3 Temperature sensor PT100 (-, RED)
X4-4 Temperature sensor PT100 (-, GRN)
X4-5 Ext relay control 3 (default) or Ext voltage +12 V (chosen by
jumper X11), (VIO)
X4-6 Ext relay control 1 (GRY/PNK)
X4-7 Ext relay control 2 (RED/BLU)
X4-8 GND
X5 and X8 Not used
To Next Page
Loading...