Val Controls IHP24-A User Manual

DHP-UM-013
Val Controls A/S • Limfjordsvej 3 • DK-6715 Esbjerg N • Tel. +45 7547 0600 • Fax +45 7547 0611
vc@valcontrols.com • www.valcontrols.com
Revision: 4
21/58
Value: 77%
Description: Range 0-100% Percent of memory
available for buffer configuration. Zero in a pre-
configurable device
FREE_TIME
[Diagnostic]
25
Length: 4 bytes
Read Only
Value: 0%
Description: Range 0-100% of the block
processing time that is free to process additional
blocks.
SHED_RCAS
[Others]
26
Length: 4 bytes
Read Write
Value: 640000 1/32 millisecond
Description: Time duration at which to give up an
computer writes to function block RCas locations
SHED_ROUT
[Others]
27
Length: 4 bytes
Read Write
Value: 640000 1/32 millisecond
Description: Time duration at which to give up on
computer writes to function block Rout locations
FAULT_STATE
[Options]
28
Length: 1 bytes
Read Only
Value: Clear
Condition set by loss of communication to an
output block, failure promoted to an output block
or a physical contact. When fault state condition
is set then output function blocks will perform
there FSTATE actions.
SET_FSTATE
[Options]
29
Length: 1 bytes
Read Write
Value: Off
Description: Allows the fault state condition to be
manually initiated by selecting Set.
CLR_FSTATE
[Options]
30
Length: 1 bytes
Read Write
Value: Off
Description: Writing a Clear to this parameter
will clear the device fault state if the field
condition if any has cleared.
MAX_NOTIFY
[Alarms]
31
Length: 1 bytes

Val Controls IHP24-A Specifications

General

Brand	Val Controls
Model	IHP24-A
Category	Controller
Language	English