Val Controls IHP24-A - Page 50

DHP-UM-013
Val Controls A/S • Limfjordsvej 3 • DK-6715 Esbjerg N • Tel. +45 7547 0600 • Fax +45 7547 0611
vc@valcontrols.com • www.valcontrols.com
Revision: 4
50/58
in a mode other than Auto then the set point will be
used immediately.
SP_RATE_UP
[Limits]
Description: Ramp rate at which upward set point
changes are acted on in Auto mode. In PV units per
second. If the ramp rate is set to zero or the block is
in a mode other than Auto then the set point will be
used immediately.
SP_HI_LIM
[Limits]
Description: The set point high limit is the highest set
point operator entry that can be used for the block
SP_LO_LIM
[Limits]
Description: The set point low limit is the lowest set
point operator entry that can be used for the block
READBACK
[Tuning]
Description: This indicates the read back of the
actual continuous value or other actuator position in
transducer units.