Val Controls IHP24 - Adjusting the Proportional Parameters of the Controller; Adjustment of Opening and Closing Time

DHP-UM-028
Val Controls A/S • Sallingsundvej 5 • DK-6715 Esbjerg N • Tel. +45 7547 0600
vc@valcontrols.com • www.valcontrols.com
Revision: 1
7/9
3 Adjusting the proportional parameters of the controller
The following parameters can be adjusted in ValConnect.
To setup the unit follow the next steps.
3.1 Adjustment of opening and closing time
Start by setting the desired opening and closing time, we recommend an opening time of min. 5 sec.
and a closing time of min. 5 sec.