Valco Cincinnati 3
General Information
It is the purchaser’s responsibility to ensure that all local, county, state, and national codes, regulations, rules, and
laws relating to safety and safe operating conditions are met and followed.
The best safeguard is trained personnel. The purchaser is responsible for providing personnel who are adequately
trained to install, operate, and maintain Valco components and systems.
This section contains information that is essential to the safety of personnel. Safety information is included through-
out the rest of the manual as well. The following safety conventions are used to indicate potential safety hazards:
Warnings
All personnel involved with the installation, operation, and maintenance of the equipment must read and thoroughly
understand the following warnings:
WARNING! Promptly repair or replace all worn or damaged electrical wiring
and equipment wires to avoid danger to personnel.
WARNING! Properly route all electrical wires to avoid danger to personnel
and damage to moving parts of machine.
WARNING! Disconnect all power before opening the control. Only qualified
personnel should open and service the control.
WARNING! This symbol indicates the presence of un-insulated dangerous
voltage within the product’s enclosure. This voltage may cause electrical
shock or fire. Failure to observe precaution may result in death, personal
injury, and/or equipment damage.
WARNING! This convention is used to alert the user to important installation,
operation, and/or maintenance information. Failure to observe precaution
may result in personal injury or death.
CAUTION! This convention is used to alert the user to important installation,
operation, and/or maintenance information. Failure to observe precaution
may result in damage to equipment.
Safety Information
To Next Page
Loading...
Need help?
General
