2. Usage
2.1 Turn ON
➔ Switch on the ignition.
➔ The control panel starts automatically.
➔ The current software version (1.0) and the current re-
lease appear on the display (Fig.5).
➔ After four seconds the default screen is displayed. (Fig.6).
2.2 Turn OFF
➔ Switch off the ignition.
➔ The system powers down.
2.3 Driver’s workplace functions
2.3.1 Adjust Temperature
2.3.2 Adjust blower speed
The temperature for the driver’s seat cannot be ad-
justed. The temperature control for the driver’s work-
place does not control the temperature, but the de-
gree of opening of the hot water valve. This results
in an uncontrolled outlet temperature.
The blower can be set from 20 to 100 in steps of
10. 20 is the smallest blower speed, on level 100
the blower runs at full speed. If the knob is turned
counterclockwise to its most left position, on the
screen displays “OFF” and the blower is switched
If the defrost function is active the blower runs on
maximum speed
Figure 5 - SC1000 Release
Figure 6 - SC1000 Standard Screen
To Next Page
Loading...
Need help?
General
