35
Periodic Maintenance
The 4100 Series of ohmmeters do not require any periodic maintenance other than an occasional
cleaning of the exterior surfaces of the product and routine performance of the calibration
procedure.
Loose dirt or dust which may have collected on the exterior surface of the ohmmeter may be
removed with a soft cloth or brush. Any remaining dirt may be removed with a soft cloth dampened
in a mild soap and water solution.
Do not use abrasive cleaners on the ohmmeter!
The front panel may be cleaned with a soft cloth and a "Windex" type cleaner if required.
Do not
use petroleum based cleaners on the front panel.
If required, the interior of the product may be cleaned out by blowing with dry compressed air.
If the product has become heavily soiled with dirt or other contaminants it is recommended that the
unit be completely overhauled. Contact Valhalla Scientific Calibration Center for details.
Valhalla Scientific, Inc.
Calibration Center
8318 Miramar Mall
San Diego Ca, 92121
Phone: 858/457-5576
Fax: 858/457-0127
e-mail: valhalla@valhallascientific.com
To Next Page
Loading...
Need help?
General