Operation VALMAR
Page
16
Figure 4 - 10: Range & Speed Selection
Speed Selection
1. Release the clip on gearbox speed
shifter and lift up.
2. Move the speed shifter sideways to the
correct numbered detent position. Drop
the speed shifter into the detent slot.
3. Rotate the gearbox manually to ensure
proper gear engagement. Lock the
speed shifter in place by pushing down
on the clip.
Funnels
Two funnels are provided for each machine for
calibration and for emptying the hopper.
Remove or install the funnels by rotating the
storage latch until they are released or secured.
Storage
2055: The funnels are stored on the front left
and right inner sides of the hopper as noted in
Figure 4-11.
Figure 4-11: 2055 Funnel Storage
2455 / 3255: The funnels are stored under the
front of the platform as shown in Figure 4-12.
Figure 4-12: 2455/3255 Funnel Storage
Installing the Funnels
1. Remove the funnels from their storage
positions.
2. Pull on the manifold latches shown in
Figure 4-5 to lower the manifold.
3. Place the wide end of the funnels under
the front edge of the metering lip. Make
sure the tabs on the back of the funnels
engage two venturi cups.
To Next Page
Loading...