Place the slider into the mixer:
insert the mixer into the cylinder:
Hold the beater with both hands and slide it slowly into the cylinder. Place the
beater so that the spade which has the slider closest to the inside of the cylinder
is facing downwards. Slowly push the beater towards the end of the cylinder.
When the beater shaft is in hole find the final position by slowly spinning the
beater clock wise and gently pushing it inwards.
close the door.
the proper installation of the blades on the mixer is checked by a TEST
RUN (see chapter MAINTENANCE OF THE APPLIANCE)
To Next Page
Loading...
Need help?
General
