VALPAR VCWS08 - Trouble Shooting Table; March 15, 2003 to Present

3
7
VCWS08 TROUBLE SHOOTING TABLE
MARCH 15, 2003 TO PRESENT
PROBLEM POSSIBLE CAUSE SOLUTION
1) IMPROPER
MICROSWITCH BEND
REALIGN
MICROSWITCH REFER
TO SECTIONS 8E, 9.3, 9.4
7D PINS JAM BEHIND
THE MICROSWITCH
2) WHEEL SPEED IS TO
GREAT
ADJUST WHEEL SPEED
REFER TO SECTION 8C
OR 8D
1) SPEED ADJUSTED
INCORRECTLY
ADJUST THE WHEEL
SPEED REFER TO
SECTION 8C OR 8D
2) LID OF #8 IS OPEN CHECK FOR
OBSTRUCTIONS, CLOSE
LID AND SNAP
LATCHES
3) KICK-OFF ANGLE IS
MISSING OR NOT
ALIGNED
CORRECTLY
REPLACE KICK OFF-
ANGLE REFER TO
SECTION 8G
7E PINS AND COLLARS
DO NOT SORT OR
DROP PROPERLY
4) DEFECTIVE MOTOR REFER PROBLEM TO
VALPAR CUSTOMER
SERVICE
1) IMPROPER
MICROSWITCH BEND
REALIGN
MICROSWITCH REFER
TO SECTIONS 8E, 9.3, 9.4
7F COLLARS JAM AT
BACK OF WHEEL OR
LAND IN THE
CENTER
2) KICK-OFF ANGLE IS
MISSING OR NOT
ALIGNED
CORRECTLY
REPLACE KICK OFF-
ANGLE REFER TO
SECTION 8G
1) IMPROPER
MICROSWITCH BEND
REALIGN
MICROSWITCH REFER
TO SECTIONS 8E, 9.3, 9.4
2) CLIENT LOSES PARTS REMOVE PARTS FROM
INSIDE REFER TO
SECTION 8H
7G PARTS ARE LOST
INSIDE THE VCWS08
3) IMPROPER DROP
BOARD ANGLE
REFER PROBLEM TO
VALPAR CUSTOMER
SERVICE
7H MOTOR RUNS BUT
THE WHEEL DOES
NOT TURN
1) LOOSE PEDESTAL
SET SCREWS
TIGHTEN SET SCREW
REFER TO SECTION 8J