6
8F REPLACING THE COUNTER
MODELS BUILT FROM MARCH 15, 2003 TO PRESENT
Remove the two mounting screws from the face of the counter. Gently pull the
counter out from the side of the work sample until the wires are exposed. Unplug the
wires from the old counter. Be careful not to let the wires fall inside the work
sample. Plug the wires into the new counter. Mount the counter to the work sample
using the same two screws.
8G REPLACING THE KICK-OFF ANGLE
MODELS BUILT FROM MARCH 15, 2003 TO PRESENT
If the assembly parts are not sorting correctly, or if they jam, or land on the
middle of the wheel, the kick off angle needs to be replaced. Open the work sample
lid. The proper location for the kick-off angle is one half inch from the bottom of the
lid retainer ring (the retainer ring is the curved piece on the inside of the lid). Mount
the new angle under the bottom center of the ring with the screws facing to the right.
To Next Page
Loading...