Value Hobby LASER - Motor, Prop, and Electronics Setup; Step 1: Install Motor; Step 2: Mount Propeller; Step 3: Install Battery and Electronics

www.valuehobby.com/8mm-epp-laser.html
11
Section4. Motor and Prop Installation
Step1. Install the 2206 motor to the motor mount.
Step2. Install 8 x 4 prop to the motor.
Step3. Install the battery and electronics to the
fuselage.
Section5: Set up CG and control thro
The recommended CG is 218mm (8.6in) from the
nose of the fuselage.
Exponential for 3D flying