Need help?Do you have a question about the Value Hobby LASER and is the answer not in the manual?
General| Brand | Value Hobby |
|---|---|
| Model | LASER |
| Category | Toy |
| Language | English |
Protect eyes and body when using tools and adhesives. Keep equipment away from children.
Operate responsibly in safe, open areas away from spectators and vehicles. Not a toy.
Install the aileron, elevator, and rudder servos onto the fuselage from nose to tail.
Slide the vertical fuselage into the horizontal fuselage, aligning tabs with slots.
Use foam safe glue and a square to join the vertical and horizontal fuselage sections.
Use a knife to cut a 45-degree bevel on the glue edges of the zigzag component.
Position the zigzag component onto the fuselage and glue it from tail to front.
Locate the necessary items for servo linkage installation as shown in the image.
Use thin CA glue and heat shrinking tube to connect the pushrod to the carbon fiber rod.
Cut a slot for the horn along the marked line on the aileron and glue it.
The recommended Center of Gravity (CG) is 218mm (8.6 inches) from the nose.
Recommended control throws for Aileron, Elevator, and Rudder for 3D flight.
To Next Page
