www.vanatoo.com 9
Step 3: Connect the active speaker to your audio device
Turn the volume control (10) on the speaker and audio device down to minimum. 1.
Find the correct input connector for your audio device on the active speaker back 2.
panel (2, 3, 5, or 6). Connect the device using the appropriate cable and turn it on.
Turn the power switch to the 3. ON position (12). The blue LED (11) will light up
within 5 seconds to indicate power to the unit.
TI P
An auxiliary AC power output (14) is provided as a convenient source of power for
your audio device.
T he AUX AC power connector is not fused and is not switched (i.e. it is live
whenever the active speaker is plugged into the wall power, regardless of the
position of the on/off switch).
TI P
If you are using a wireless network device, or connecting to a computer using the
USB port, there may be additional setup necessary on your audio source. Consult
the device manufacturer for setup instructions.
TI P
While adding or removing cables with the power on won’t damage your speakers,
we recommend that you turn them off rst.
Step 4: Optimize for your space
Vanatoo knows each customer’s environment and listening preferences are different.
Transparent One speakers have bass, treble, and volume adjustments, and allow you
to choose whether the active speaker is in the left or right position.
Locate the L–R switch (1) on the back of the active speaker.1.
Set the switch to designate whether the active speaker is the speaker on your left 2.
(L) or right (R) when you are facing both of the speakers from the front.
Turn the audio device volume up to ¾ to full. 3.
Turn the active speaker volume knob (10) up to the maximum volume you desire. 4.
This should provide a good volume combination so that, in the future, you should 5.
only need to adjust the volume control on your audio device to achieve your
desired listening volume. Adjust the volume combination down if your settings
cause distortion. As with all speakers, prolonged distortion can cause permanent
damage.
Rotate the treble (8) and bass (9) controls to adjust the balance as desired. In 6.
most cases, the optimum setting for a at frequency response is to set the treble
and bass knobs at the detents (straight up position). This is our default setting.
Visit our website for pointers on how to optimize the settings for different room 7.
conditions. www.vanatoo.com/audiospeak
Step 5: Enjoy!
That’s It! You are ready to enjoy your Vanatoo Transparent One speakers.
Congratulations and happy listening.
To Next Page
Loading...
Need help?
General
