Vanderbilt SPC4 Series User Manual

Editing an ARC filter using SIA or CID
To configure the events on the SPC that will trigger the call to the ARC:
1. Select Select Communications > Reporting > Analog ARC > Edit > Filter.
The following page will be displayed:
2. Configure the following fields:
Check any of the following boxes if you want to initiate a remote call to the ARC to notify it of the
particular event.
Alarms Alarms are activated.
Alarm
Restores
System alarms are restored.
Confirmed
Alarms
Alarms confirmed by multiple zones
Alarm
Abort
Alarm Abort events. Alarms are aborted after a valid user code is entered via
the keypad after a confirmed or unconfirmed alarm,
Faults Faults and tampers are activated.
Fault
Restores
Fault or tamper alarms are restored.
Settings System is Set and Unset.
Early/Late Unscheduled setting and unsetting of the system.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 326 A6V10276959-d
11.2018

Vanderbilt SPC4 Series Specifications

General

Brand	Vanderbilt
Model	SPC4 Series
Category	Power Supply
Language	English