EasyManuals Logo

Vanderbilt SPC4 Series User Manual

Vanderbilt SPC4 Series
402 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #333 background imageLoading...
Page #333 background image
Alarm Abort Alarm Abort events. Alarms are aborted after a valid user code is entered via
the keypad after a confirmed or unconfirmed alarm,
Faults Faults and tampers are activated.
Fault
Restores
Fault or tamper alarms are restored.
Zone state Report all zone input state changes.
Settings System is Set and Unset.
Early/Late Unscheduled setting and unsetting of the system.
Inhibits Inhibit and isolate operations are performed on the system.
Door
Events
Door events are activated. Only works with SIA protocol.
Other All other types of events are detected on the system.
Other (Non
standard)
Non supported SIA codes used with SPC COM XT including Camera
Online/Offline events.
Network Report IP Network Polling Up/Down events.
Areas Select specific areas to which above events apply.
Editing EDP settings
1. Select Communications > Reporting > EDP > Settings.
The following page will be displayed.
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 333 A6V10276959-d
11.2018

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Vanderbilt SPC4 Series and is the answer not in the manual?

Vanderbilt SPC4 Series Specifications

General IconGeneral
BrandVanderbilt
ModelSPC4 Series
CategoryPower Supply
LanguageEnglish

Related product manuals