Need help?Do you have a question about the Vanderbilt V44 Duo and is the answer not in the manual?
General| Ingress Protection | IP54 |
|---|---|
| Housing Material | Zinc Alloy |
| Communication | Bluetooth, NFC |
| Power Supply | 4 x AA Batteries |
| Battery Life | Up to 2 years |
| IP Rating | IP54 |
| Material | Zinc alloy |
Explains using one code to activate two relay outputs simultaneously.
Describes limiting code access based on time zones.
Explains features related to duress codes or alerts triggered by door events.
Allows door opening via an external contact, typically for convenience.
Describes how to keep the door unlocked using a toggle function.
Details connecting and using an external door bell.
Specifies requirements for stable and uninterrupted power supply.
Explains how buzzers and LEDs guide the user during programming.
Steps to set up the initial 6-digit access password.
Instructions for modifying the existing 6-digit access password.
General information on initiating programming commands.
Guide to entering new access codes and their settings.
Steps for deleting existing access codes from memory.
Process for modifying existing access codes and their parameters.
How to configure the duration the lock remains open.
Instructions to enable or disable keypad backlight.
How to deactivate the keypad and door opening buzzer sounds.
Activates/deactivates permanent door unlocking feature.
Resets all programming to factory default settings.
Controls sequential door opening for multi-door setups.
Special code entry for threat situations.
Alarm activation for door status or forced entry.
Controls alerts based on door state (open too long/forced).
Configures the warning time for doors left ajar.
How to open the lock using a valid code.
Steps to keep the door unlocked via a specific code sequence.
Instructions for users to activate the duress signal.
To Next Page
