12 V44 Duo Installation & User manual
ENG
Program codes
1 Press B and enter the current password.
2 Enter A21.
3 Enter the desired code location using two digits (01-
30).
4 Enter the code for the current code location (four digits
for code location 01-20 or six digits for code location
21-30).
Note! The four rst digits in a 6-digit code must not be
the same as the digits in a 4-digit code and the other
way around.
5 Choose whether or not the code should be disabled
from a time clock.
0 = no time control
1 = code disabled from time clock 1
2 = code disabled from time clock 2
6 Choose which relay output to control.
0 = both relay outputs
1 = relay output 1
2 = relay output 2
7 Program the next code by continuing from step 3 or
press B to exit.
To Next Page
Loading...
