Vankyo Burger 101 - Specifications; Troubleshooting Guide; iPhone Mirroring Issues; Power On Failures

12
Specifications
Adapter Input
AC100V-240V, 50/60Hz
Adapter Output
DC5V=3A
Ports
USB Port*1/HDMI In*1/Audio Out*1/DC In*1
Operating System
Linux
WIFI
2.4G
RAM/ROM
256MB/2G bits
CPU
Mstar V66
Battery Capacity
5200mAh (Rechargeable Li-ion battery)
Display Technology
DLP
Light Source
LED
Resolution
Native 584 x 480
Projecting Distance/Size
0.8/30-110inches
Projecting Mode
Front/Rear/Ceiling
Aspect Ratio
4:3/16:9
Keystone
Auto/Manual ± 40°
Focus
Manual
Troubleshooting guide
1) The content on my iPhone cannot mirrored on the projected screen.
• Make sure your iPhone is connected to the same 2.4G network as your projector.
• Go to Setup > Information > Software Version to check the version of your
projector, then contact support@ivankyo.com for further assistance.
2) The projector cannot be turned on when I press the power button
• Connect the projector to the socket with a power cord to check whether the built-
in battery is empty.
• Make sure you switch the ON/OFF Switch to ON.
3) The projected image freezes or the projector is not responsive.
• Go to Setup > Advanced to make a factory reset.
4) 3D effect is not working as expected.
• The 3D active shutter glasses are required.
• Make sure the 3D video is in the format of side-by-side or top and bottom.
• Make sure to press the 3D button on the remote.
5) My USB disk or hard drive cannot be read.
• Make sure the format of your USB disk or hard drive is FAT32 or NTFS.
• The max. storage of the USB disk should be less than 64GB.