115
Slideout rooms are designed to provide you additional living space during stationary camping.
• Leveling helps to keep the RV square, so the slideouts extend, retract and seal correctly.
• If the RV is NOT level, the slideout rooms and/or mechanisms may become damaged.
• The slideout rooms DO NOT need additional support. Non-warranty damage can occur from improper use of
aftermarket support jacks.
SLIDEOUT OPERATION
It is normal for the slide rooms to make creaking or squeaking noises while moving. These noises are especially
common during the break-in period while the components are seating properly. This will decrease after a few ex-
tend/retract cycles. Note that there will always be some noticeable noises when operating the slideout.
1. ALWAYS level and stabilize the RV, BEFORE operating your slideout system.
2. Check that your auxiliary battery is fully charged or the RV is connected to shore power. Turn off all unnecessary
lights to maximize avaiable power.
3. Close all cabinet doors and drawers.
4. BEFORE extending or retracting:
• Check that the interior path of the slideout room is clear of people, pets, furniture, clothing, etc.
• Check that the exterior path of the slideout room is free from any obstructions.
5. Inspect the sides, top and bottom of the extended slide-out room. If the outside of the slideout room is wet,
wipe it dry before retracting.
6. Clean any water puddles or debris brought inside your RV from slideout operation immediately.
7. Press and hold the appropriate slide room switch to either IN or OUT, until the room is completely extended
or retracted.
SLIDEOUT SYSTEMS
BEFORE operating your slideout system:
• Check that you have sufficient power avaiable.
• Level and stabilize the RV
SLIDEOUT SYSTEMS
To Next Page
Loading...