EasyManua.ls Logo

VANLEIGH PINECREST - Slideout

Default Icon
158 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
135
Loose connection at light. Have connection checked by an authorized service center.
SLIDEOUT
Room moves in and out very slowly, binds or squeaks
Lubricate the slide-out tubes and rollers with light spray lube.
Water is getting in at the bottom corners of the room
Verify exterior seals are against the room at the top corners and not turned in when the room is out (horizontal seal
overaps vertical). Also, check for voids in the seal on the slide roof and side panels.
Make sure weep hole in ramp pan is open and unobstructed.
Room will not move in or out
Check the auto-resetting fuse located by the slide out motor. (See the manufacturer’s manual).
Check battery condition and state of charge. Recharge if necessary.
TERMINATION VALVE
Termination valve leaks
Debris keeps valve from seating. Clear debris from and around valve O-ring set.
Bad gasket. Have your dealer or qualified RV technician repace gasket with new.
TV ANTENNA
Poor TV reception
Power jack is OFF. Turn ON power jack switch.
Bad connections at TV or wall pate. Make sure the connections are good at both TV and wall pate.
Antenna not pointed in direction of sending station. Point antenna in proper direction.
Cut or torn cable. Have your dealer or qualified RV technician repace bad cable where needed at TV and antenna.
Antenna will not rotate
Make sure button on the side of knob is fully depressed.
Possible obstruction (tree branch, etc.). Remove the obstruction.
Check to make sure roof seaant is not restricting rotation.
BASIC TROUBLESHOOTING

Table of Contents