14 15
5.7. Configure your OWM7111 to your needs
Accessing the OWM7111 web interface
The OWM7111 web interface allows you to congure your OWM7111 using
your web browser. To access the OWM7111 web user interface:
1 Check the IP address of your OWM7111. If your OWM7111:
Is connected to your network (either wired or via Wi-Fi), browse to the
web interface of your gateway to check the IP address of the OWM7111.
Not connected to your network, the default IP address of the OWM7111 is
192.168.1.2.
2 Browse to the OWM7111’s IP address found (or hp://192.168.1.2) on a
computer or device that is currently connected to your OWM7111 (either
wired or over Wi-Fi).
3 The OWM7111 web interface appears. By default, you are logged in as guest.
This means that some items are hidden. To view all items, click Sign In and
enter admin as user name and the ACCESS KEY printed on the label of your
OWM7111 as password.
Note: If this is the rst me that you sign in, the OWM7111 may oer you to
change your password.
4 The OWM7111 web interface appears with all sengs available.
Configuring Easy Mesh
To use EasyMesh you must rst enable it on your OWM7111. To enable
EasyMesh:
1 Browse to the OWM7111 web user interface and login as the user admin
(for more informaon, see “Accessing the OWM7111 web interface” on
page 14.
2 To open the EasyMesh page, click the EasyMesh card header.
3 On the EasyMesh page, you can see whether EasyMesh is enabled on your
OWM7111 or not. If the switch is set to:
then the EasyMesh agent is enabled. Clicking the switch will disable
EasyMesh on your OWM7111.
then the EasyMesh agent is disabled. Clicking the switch will enable
your broadband interface.
5.8. How to repair an unresponsive OWM7111
If at some point your OWM7111 becomes unresponsive you can:
• Force it to restart: Aer restarng the OWM7111 will return to normal oper-
aon with its last known working condion and conguraon.
• Reset it to factory defaults: The OWM7111 restarts with the factory default
conguraon. None of the Wi-Fi and EasyMesh sengs, nor other congura-
on changes you made to the OWM7111 are preserved.
Proceed as follows:
1 Make sure that your OWM7111 is turned on.
2 Use a pen or an unfolded paperclip to push the recessed Reset buon on
your OWM7111:
shortly (less than 5 seconds) and then release it to force it to restart.
for at least 10 seconds and then release it to rest it to factory defaults.
3 Your OWM7111 restarts.
To Next Page
Loading...