Vapac LE60-110 - User Manual

These instructions contain operating information and should be left with the unit.
Electrode Boiler Units
LE
Installation & Operation Manual
Edition 3.2.2
(For use with Software version 7.1 & subsequent issues)
Installation in countries covered by EC Directives:
This product meets the requirements of the RoHS Directive 2002/95/EEC
This product will meet the requirements of the Low Voltage Safety Directive 2006/95/ EEC and the EMC
Directive 2004/108/ EEC when installed in accordance with the instructions contained in this manual.
Failure to comply with these instructions may invalidate the manufacturer's warranty or any
certificate/declaration of conformance requested to be supplied with the unit.

Summary

Installation

Positioning the steam pipes

Provides guidance on steam pipe placement, slope, and connections.

Plumbing Considerations

Outlines requirements for water supply, quality, and drain connections.

Electrical Connections

Covers power supply, EMC, and wiring details for electrical connections.

Cylinder Electrical demand loads

Presents electrical load data for various LExx and LExxP unit models.

Control Circuit Connections

Explains control wiring, signal selection, and circuit options for Vapac units.

Start-Up; Operation

Service Advice

Advice and procedures related to unit maintenance and servicing.

Location of Indicators and Controls

Initial Set-up

Details the initial setup process and user LED states during initialization.

Fault; Service Indications - Requiring Operator Intervention.

Describes fault and service indications requiring operator intervention and LED status.

Trouble-shooting Check List

Wiring diagram

Vapac LE60-110 Specifications

General

Model	LE60-110
Power Output	60 kW
Power	60 kW
Voltage	400 V
Phase	3
Water Connection	1 inch
Steam Output	90 kg/h
Heating Capacity	60 kW
Efficiency	98%