What causes a starved spray pattern in Vaper Paint Sprayer?
A starved spray pattern from your Vaper Paint Sprayer can be due to inadequate material flow, low atomization air pressure (suction feed), or too much atomization air pressure. Back the fluid adjusting screw out to the first thread or increase fluid pressure at the tank. Increase air pressure and rebalance the gun. Reduce pressure.
Why does my Vaper Paint Sprayer have a split spray pattern?
A split spray pattern with your Vaper Paint Sprayer can be caused by atomization air pressure that is too high, fluid pressure that is too low (pressure feed only), or a spreader adjusting valve set too high. Reduce the air pressure at the regulator or gun. Increase fluid pressure (this increases gun handling speed). Adjust the spreader adjusting valve.
Why does my Vaper Paint Sprayer have a heavy top or bottom pattern?
A heavy top or bottom pattern from your Vaper Paint Sprayer can occur if the horn holes are plugged, there is an obstruction on the top or bottom of the fluid tip, or the cap and/or tip seat are dirty. Clean the horn holes and ream with a non-metallic point. Clean the obstruction. Clean the cap and/or tip seat.
Why does my Vaper Paint Sprayer have a heavy right or left side pattern?
A heavy right or left side pattern with your Vaper Paint Sprayer is often caused by plugged left or right side horn holes or dirt on the left or right side of the fluid tip. Clean the horn holes and ream with a non-metallic point. Clean the dirt from the fluid tip.
How to get round spray with Vaper Paint Sprayer?
If you are unable to get a round spray from your Vaper Paint Sprayer, it could be that the spreader adjustment screw is not seating properly or the air cap retaining ring is loose. Try cleaning or replacing the spreader adjustment screw. Tighten the air cap retaining ring.
Why Vaper Paint Sprayer will not spray?
Your Vaper Paint Sprayer might not spray if there is no air pressure at the gun, an internal mix or pressure feed air cap and tip are used with suction feed, the fluid pressure is too low with an internal mix cap and pressure tank, the fluid needle adjusting screw is not open enough, or the fluid tool is heavy for suction feed. Check the air supply and air lines. Change to the proper suction feed air cap and tip. Increase the fluid pressure at the tank. Open the fluid needle adjusting screw. Thin the material or change to pressure feed.
Read and understand this entire instruction manual before operating the spray gun for safety.
Spraying flammable materials creates an explosion or fire risk due to atomized particles mixed with air.
Certain solvents can react with aluminum, creating an explosion hazard.
Risks include flying objects, injection injuries from high pressure, and bursting of parts.
Inhaling paints or solvents can cause lung damage, burns, or other health issues.
Always use an OSHA/NIOSH approved respirator and wear safety goggles for protection.
Warnings against unclogging the gun improperly and exceeding pressure limits.
Keep gun perpendicular, 6-12 inches from surface, maintain motion, trigger properly, use lowest atomizing pressure.
Warnings for shutting off air supply and safe hose blow-out procedures during cleaning.
Addresses heavy top/bottom, right/left patterns, heavy center patterns, and split spray patterns.
General| Brand | Vaper |
|---|---|
| Model | HVLP |
| Category | Paint Sprayer |
| Language | English |
To Next Page
