What to do if the red pilot light is out on my VASTEX Accessories?
If the red pilot light is out on your VASTEX Accessories, there could be several reasons: * **Loose connections:** Ensure all connections are secure. * **Power issues:** Check if there's a power failure or outlet malfunction at the main disconnect. * **Controller malfunction:** The controller might be faulty, requiring a replacement.
What to do if the belt stopped but the motor is still turning on my VASTEX Accessories?
If the belt has stopped on your VASTEX Accessories and the motor is still turning, it may be due to: * Worn components: Replace the chain and worn sprockets. * Loose set screws: Tighten the sprocket set screws.
Why is the heat not cycling on and off on my VASTEX Accessories?
If the heat is not cycling on and off in your VASTEX Accessories, it's likely due to a bad controller, which would need to be replaced.
Why is the red light on my VASTEX Accessories?
If the red light is on for your VASTEX Accessories, it might be due to: * Loose connections: Check all connections to ensure they are secure. * Controller malfunction: The controller could be bad and needs replacement. * Heater issue: The heater might be faulty, requiring replacement.
Essential safety precautions for operating the conveyor drying system.
Information on equipment stability, lifting, and safe transport.
Steps for starting the dryer and curing different ink types.
Steps for safely powering down the conveyor dryer.
Guidance on setting belt speed pots and resolving speed issues.
Solutions for common issues like no heat or belt stopping.
General| Brand | VASTEX |
|---|---|
| Model | DB-30 |
| Category | Accessories |
| Language | English |
To Next Page