Irrigator
Unpack machine and place on a level surface approximately 500mm o the ground using stands or
similar. Set frame as level as possible.
Using the M12 bolts provided, attach the rear axle. Lightly tighten the bolts located at the top of the
frame. Using a spirit level placed front to back across the ange on top of the rear axle, adjust the
M16 thread between the axle and the frame until the ange is level. At this point tighten all bolts on
the rear axle (6 x M12 bolts and 2 x M16 threads).
Using clip provided, slide bar on front axle assembly into pipe at front of machine with one washer
under the pipe and one above then replace clip.
Bolt on all four wheels.
Next bolt riser assembly to onto the top of the rear axle ensuring the rubber gasket is between the
anges then tighten the four bolts (4 x M16)
Next attach the head unit to the riser ensuring the rubber gasket is between the anges then
tighten the bolts (8 x M16)
Arms
Wrap Teon tape on all external threads
Screw 50mm sockets onto head unit (x4) then screw a length of pipe into each socket.
As you go, attach cable to the plate at the top of the head unit using the supplied D shackles and
then clamp near the end of the pipe. Tighten the turnbuckle until the cable is taking the weight o
the threads. Repeat for the other three arms.
Outer arms are now ready to be installed. Screw outer arm onto arm assembly. These should be
approximately 45° to the ground and facing anti clockwise as to rotate in a clockwise direction (see
page 7 of this manual) then adjust as required.
A single rotation should take between 4-5 seconds.
QUAD Assembly
To Next Page
Loading...