Setting Irrigator to Start
Disengage front and rear pawls using the pin for the front pawl and the chain for the rear pawl.
Run out the desired length of cable and attach to a suitable anchor. A star picket driven into the
ground at an angle is normally sucient.
Return to irrigator, re-engage pawls ensuring they ‘seat’ into the sprocket.
Attach hose to the rear of the irrigator. Hose should run parallel to the machine approximately 2-3
metres to the side with an even loop into the rear of the irrigator (see page 7 of this manual) and
take up any slack in the cable.
Stand clear and activate water supply to irrigator.
Speed adjustment can be achieved by removing individual cams from the riser unit. Eg. removing 2
cam plates will halv the speed and therefore doubling the water applied
QUAD Operation
To Next Page
Loading...