12
❑ Do not apply heat to brass fittings.
6. WATER SUPPLY CONNECTIONS
❑ See INSTALLATION DIAGRAM 1 on page 20 and INSTALLATION
DIAGRAM 2 on page 20.
❑ Do not over tighten brass threads.
❑ Do not apply heat to brass fittings.
❑ Mark the water shutoff for future reference.
❑ If there is a check valve (sometimes in water meter), backflow
preventer or pressure-reducing valve, install an adequate size
expansion tank.
7. FILLING THE HEATER
❑ Water connections completed and free of leaks.
❑ Check for proper installation of the temperature and pressure relief
valve.
❑ Close drain valve.
❑ Open the highest hot water faucet.
❑ Open cold water inlet valve and fill system.
8. WIRING
❑ Verify that wiring matches thermostat diagrams.
❑ Check that water heats to desired temperature.
9. INSTALLATION COMPLETED AND CHECKLIST FILLED
OUT
BY: ____________________________________________________
DATE: _________________________________________________
NOTES: ________________________________________________
To Next Page
Loading...
