Vax Air Lift Steerable UCPESHV1 - Taking Care of Your Machine; Emptying and Cleaning the Dirt Container; Cleaning the Pre-Motor Filter

Press the dirt container
release buttons located the
side of the carry handle.
Lift the dirt container lid
release clip. In a hinge
like manor lift the dirt
container lid.
Tap the lter over a bin
to remove any dirt/debris.
Wash the lter under
running water (40
degrees max).
Leave for 24hrs or until fully
dry before replacing.
Pull the pre-motor lter tab
and remove the lter from
the dirt container.
Emptying and cleaning the dirt container
Cleaning the pre-motor lter
Taking care of your machine
IMPORTANT: The motor is equipped with a thermal cut-out. If for any reason the machine should overheat, the thermostat
will automatically turn the machine o. Switch o and unplug the vacuum cleaner. Check the machine for blockages and
clean the lters . Wash the lters with warm water (40°C max) and leave for 24 hours or until fully dry before replacing into
the machine.
For best cleaning results, lters should be tapped over a bin every 4-6 uses to remove dirt and debris and washed every
3 to 6 months (depending on the level of use). Don’t use your vacuum cleaner without all of the lters in place.
Pull and remove the
dirt container o the
vacuum cleaner.
Hold the dirt container over
a bin, press the dirt release
button to open and allow the
dirt to fall out.
24hrs
MA
X
40˚C
TIP
Don’t over ll the dirt
container to avoid
blocking the air ow
through the vacuum
cleaner and replace
lters every 6-9 months.