Vax Service line: AU: 1300 361 505
NZ: 0800 800 900
vax.com.au
4
General Safety Information
NOTE: If the supply cord is damaged it must be replaced by
the manufacturer, or a similarly qualified person in order to
avoid hazard, or invalidating the warranty.
IMPORTANT: The motor is equipped with a thermal cut-out.
If for any reason the unit should overheat (eg. from blocked
nozzles, a full dust container or unclean filters), the thermostat
will automatically turn off the switch. Should this occur,
unplug the vacuum cleaner from the electrical socket and
turn off the switch. Remove dirt container and empty. Clean
filters. Allow the unit to cool for approximately one (1) hour.
To re-start, plug into an electrical socket and switch back on.
DAMAGE TO THE VACUUM CLEANER CAUSED AS A DIRECT
RESULT OF NOT ADHERING TO THE GENERAL SAFETY
INFORMATION AND THE INSTRUCTIONS IN THIS USER GUIDE
INVALIDATES THE WARRANTY
This vacuum cleaner is intended for household use only and NOT
for commercial or industrial use.
PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
To Next Page
Loading...
